B.S. Degree with a Major in Technology and Applied Design with an Engineering and Technology Education Concentration
The Technology and Applied Design: Engineering and Technology Education concentration prepares students interested in gaining certification to teach in the area of engineering and technology education (5-12). The student must double major in Teaching and Curriculum with Certification and in Technology and Applied Design: Engineering and Technology Education concentration. For more information see the requirements for majoring in Teaching and Curriculum with Certification under the Education Studies section of this publication. A major in Technology and Applied Design: Engineering and Technology Education Concentration is achieved by the completion of the following requirements, in addition to the General Education and electives required for a degree:
Requirements for the Major
Required Core Courses
TAD 130, 140, 180, 245, 265, and 275
Required Capstone Course
Required Distribution Courses
Three (3) advanced courses, chosen from TAD 330, 340, 345, 352, 382, 455, 460, 470, or other courses approved by the Program;
Required Collateral Courses
MAT 115 of higher Two (2) additional course credits, chosen from: ART 110,CSC 111, 125, 126, SENS 100 or other TAD courses Three of the following courses; EDS 150(required); PHY 217 (required) or higher; and one of the following: ANR 130 or 240, BIO 100 or 110, CHM 101, EDS 228, WGS 310
Exploring the Major
Students with interests such as education, engineering, architecture, or other special areas relating to technology should consult with a faculty member in the Program.
Admission to the Major
No additional or special curricular requirements must be met for admission to this major.